| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
f.
Remove the filter head (5).
REPAIR
Repair to the water filter is by replacing parts or the assembly. Refer to the Removal and Replacement steps.
REPLACEMENT
a. Install the filter head (5) with washer screws (2) to the bracket (1). Tighten the screws to 30 to 35 ft-lb
40.6 to 47.4 N ) torque.
m
b. Install hoses (9) to the filter head elbows (7) and valves (10) with th hose clamps (8). Tighten clamps
e
(8) to 35-40 in-lb (3.9 to 4.5 N ) torque.
m
c.
Apply a light coat of lubricating oil to the sealing gasket of a new fluid filter (11).
CAUTION
Do not use a wrench to tighten the filter. Overtightening can
damage the threads and the seal.
d. Install a new filter (11) onto head (5). Hand tighten the filter (11) until the sealing gasket touches the
head (5). Then tighten an additional 1/2 to 3/4 turn.
e. Open the water inlet and outlet angle valves (10) on e ch side of the filter assembly and check for
a
leaks. Correct as required.
f.
Install the radiator or fill cap (if any coolant is required, refer to PMCS, Item 24).
2-67
|
||
|
||
