| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
REPAIR
Repair of the Lubricating Oil Cooler/Filter Group is by replacement of parts listed in Materials/Parts.
REPLACEMENT
a. Install a new oil cooler support gasket (6).
b. Position the oil cooler housing (4) and oil cooler support (5)on the cylinder block.
c.
Install machine screws (7), capscrews (9) and lockwashers (8). Tighten the capscrews to 30 to 35 ft-lb
(41 to 47 N ) torque.
m
d. Install capscrew (1) and washer (2) in the angle bracket (3). Tighten the capscrew to 30 to 35 ft-lb (41
to 47 N ) torque.
m
e. Install the water transfer tube (17) into the rear of the oil cooler housing (4). Install preformed hose (20)
and hose clamps (19).
f.
Install the fluid filter head (16), using new preformed packing (10) and gask t (11), with flat washer
e
(15), lockwasher (14), and assembled washer screw (13).
NOTE
Fill the fuel filter element with clean lube oil before installing.
g. Apply a coat of clean oil to the sealing gasket of the fluid filter element (12). Install the fluid filter
element (12) and hand tighten until gasket touches sealing surface, and hand tighten an additional 1/2
to 3/4 turn.
h. Connect the coolant heater hose with clamp to the transfer tube (17) at point (18).
NOTE
Ensure there is a minimum of 0.250 inch (6.3 mm) clearance
between the filter and the oil pan flange of the cylinder block.
i.
Fill the cooling system.
j.
Remove tags, turn ON electrical power, start the engine (TM 55-1905-223-10),and check for leaks.
Correct as required.
2-93
|
||
|
||
