| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
FIGURE 3-41. Removing Gear Cover.
h. Remove assembled washer screws (9, Figure 3-38) and the remaining gear cover (10) screws (8, 12).
Remove the gear cover (10). The pins (7, 13) will remain in the block until installation.
i.
Remove the plain encased seal (11) and accessory drive seal (1) from the cover (10).
j.
Remove the gasket (3). Discard gasket.
REPAIR
a. Clean and inspect gear cover.
(1)
Clean the gear cover and cylinder block gasket surfaces.
(2)
Clean gear cover with solvent.
(3)
Visually inspect the gear cover for cracks or damage. Replace cover if damaged.
(4)
Use a clean cloth to clean the crankshaft seal bore.
b. Clean the inspect camshaft bearing support.
(1)
Clean the bearing support and shims with solvent.
(2)
Visually inspect the bearing support for cracks or damage on the thrust surface. Replace bearing
support if damaged.
3-79
|
||
|
||
