| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
FIGURE 3-83. Dampener and Pulley Removal.
CAUTION
Do not use a hammer or screwdriver to remove dampener.
These tools may
damage the dampener.
d. Remove the remaining five capscrews and washers, the dampener, and the pulley.
e. Inspect the dampener as follows:
(1) Apply a spray of Spotcheck Developer, Type SKD-NF, or equivalent on the dampener. Put the
dampener in an oven heated to 200 F (93 C). Let the dampener reach the temperature inside
the oven, and then remove it.
(2) Inspect the dampener for oil leaks. Discard the dampener if any leaks are seen.
(3)
Remove the paint from four areas on each side of the dampener.
Use these areas to take
measurements of the thickness of the dampener.
CAUTION
Do not use coarse emery cloth or a sharp tool to remove the paint. Use cleaning
solvent and 240 grit emery cloth.
(4) Use a micrometer to measure the thickness at each of the four areas. Measure approximately
0.125 inch (3.18 mm) from the outside diameter of the dampener.
3-133
|
||
|
||
