| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
NOTE
Keep the camshaft in a vertical position with the gear up until the gear has
cooled.
(f)
If the gear does not seat against the locating shoulder on the camshaft, use a brass drift and a
hammer to drive the gear up against the shoulder.
(g)
Use a feeler gauge to check the clearance between the camshaft gear and the shoulder. The
clearance must not exceed 0.0050 inch (0.13 mm). See Figure 4-24.
c.
Install the camshaft (paragraph 3-23).
NOTE
Check the engine timing after engine assembly has been completed (paragraph 3-18).
4-69
|
||
|
||
