| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
FIGURE 4-55. Checking Liner Bore.
2
Measure each point in the direction "AA" and "BB".
3
At point "C", the liner cannot be more than 0.003 inch (0.08 mm) out-of-round.
4
At points "D", "E", "F", and "G", the liner bore cannot be more than 0.002 inch (0.15 mm).
(i) Check the following and replace liners again as necessary.
1
Liner protrusion.
2
Liner and cylinder block lower liner bore.
3
Liner bore out-of-round.
(j) Check for twisted preformed packing.
(k) Clean the liner flange and the cylinder block liner counterbore.
(l) Inspect the liner flange for burrs.
4-108
|
||
|
||
