| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
FIGURE 4-58. Bushing Driver Identification.
(5) Install the tool assembly through the camshaft bore until the driver is in the cavity between the
bores where the bushing is to be installed.
(6) Install the bushing guide in the camshaft bore next to the bore where the bushing is to be installed.
(7) Install the bushing marked for that location on the driver with the locating notch to the rear of the
engine and at the 9 o'clock position.
(a) Push the bushing in the bore until the oil holes in the bushings are aligned with the drillings in
the bore.
(b) Use a 0.094-inch (2.39 mm) diameter rod to check the position and the location of the oil hole
in the bushing and the cylinder block.
(c) The rod must pass through the oil holes in the bushing and into the oil supply drillings in the
cylinder block.
NOTE
The camshaft bushing guide is not used to install the No. 1 bushing.
(8) Install bushing No. 1 on the driver with the notch to the rear of the engine and at the 9 o'clock
position when looking at it from the front of the engine.
4-112
|
||
|
||
