| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
SECTION IV. REMARKS
SHIP'S SERVICE GENERATOR SET
REFERENCE
REMARKS
CODE
A
Depot maintenance will be performed on a case by case basis subject to approval
and funding by the National Maintenance Point (NMP).
B
This item is a candidate for direct exchange with the vendor.
C
During disassembly of the engine, put a cover tape over the inset and olutlet of
the turbocharger.
D
Remove the capscrews in the opposite sequence as that used for installing the
cylinder heads
E
When a flanged locknut is used to hold the pulley on the shaft, you must not let
the accessory drive shaft turn when the locknut is removed. When the flanged
locknut is installed, it is tightened to 270 to 340 ft. lbs. torque.
F
Do not use a hammer or screwdriver to remove the caps from the connecting
rods.
G
Do not use a hammer or other tools to remove the piston pin.
H
You do not need to use shims for thecylinder liner unless the counterbore has
been repaired.
I
Inspect the cylinder block on a flat surface to prevent distortion. Do not inspect
the cylinder block in the engine stand.
J
Electric start engine.
K
Air start engine.
L
Used on electric start engine only.
M
Used on air start engine only.
*U.S. GOVERNMENT PRINTING OFFICE: 1994 - 555-028/000212
PIN: 065781-005
Change 5
B-20
|
||
|
||
