| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
m.
Remove panel light assembly (4).
n.
Replace gauges which are defective, damaged, or not working.
o.
Replace damaged or frayed wiring harnesses (14, 15, 16).
REPLACEMENT
a.
If a defective gauge (5, 1, 2), switch (17, 18, 22), meter (20, 21, 23), or light (4) unit is being
replaced, do the following:
(1)
Position the new part in the panel and install the mounting hardware that holds it to the
panel.
(2)
Connect electrical wiring harnesses (14, 15, 16).
(3)
Install mounting bracket (9) if it was removed, using mounting bolts, washers, and nuts
(10).
b.
To replace the instrument panel assembly:
(1)
Install wiring harnesses (14, 15, 16) that were removed. Make sure all wires are
connected to proper locations.
(2)
Position panel box (12) in the mounting bracket (9) and install the washers and nuts (8)
on each corner of the panel box (12). Secure the screws.
(3)
Plug in harnesses (14, 15, 16), to the panel box (12).
(4)
Connect all electrical wiring to engine.
(5)
Connect thermocouple (7). Close panel front and secure the two pinhead screws (3).
c.
Check and secure the electrical connections to the starter motor.
d.
Remove "Out of Service-Do Not Operate" tags.
2-60
|
||
|
||
