| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(2)
Use the puller jack screw to exert force on the INPUT END of clutch shaft
(33); remove clutch assembly (6 through 23) from clutch shaft (33).
Remove machine key (34).
i. Place clutch assembly (6 through 23), with nonmetallic hose assembly (24)
attached, on work bench with sliding sleeve assembly (16) facing up.
j. Install the two helical compression springs (32) and machine bolts (31)
removed in step g. Tighten machine bolts until their shoulders contact the
hub and back plate (6); then tighten to 160-175 ft-lb torque.
k. Remove lubrication fitting (30) from tube elbow (27).
l. Remove tube elbow (27) from nonmetallic hose assembly (25).
m. Remove nonmetallic hose assembly (25) from pipe to tube elbow (26) on the
collar (21).
n. Remove pipe to tube elbow (26) from collar (21).
INSPECTION
a. Inspect nonmetallic hose assembly (24) and nonmetallic hose assembly (25) for
cuts, cracks, or swollen hose.
b. Inspect nonmetallic hose assembly (24) for loose or leaking fittings (26 and
27).
c. Replace nonmetallic hose assembly (24) if damaged.
REPAIR
Repair of the power take-off assembly (1) consists of replacing nonmetallic hose
assembly (24).
REPLACEMENT
a. Install pipe to tube elbow (26) on collar (21).
b. Connect nonmetallic hose assembly (25) to pipe to tube elbow (26) on collar
(21).
c. Connect tube elbow (27) to other end of nonmetallic hose assembly (25).
d. Partially install machine key (34) into clutch shaft (33) keyway.
2-152
|
||
|
||
