| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
FIGURE 3-47. PTO Housing and Mounts .
c.
Remove the camshaft support and the thrust bearing:
(1)
Remove the three capscrews (3, FIGURE 3-48) and lockwashers (1) from the support
(2).
(2)
Use a rubber or plastic hammer to rotate the bearing support (2) approximately 60
degrees.
(3)
Use a suitable pry bar to remove the bearing support (2) from the gear cover.
CAUTION
If the accessory drive dowel pin has been incorrectly installed, the dowel pin must be
removed before attempting to remove the gear cover to prevent damage to the
accessory drive bushing (FIGURE 3-49).
(4)
Remove the preformed packing and the shims from the bearing support. Do not
dispose of the shims (2, FIGURE 3-50).
d.
Remove the four capscrews which hold the oil pan to the gear cover.
e.
Loosen all remaining oil pan mounting capscrews four to five turns.
3-70
|
||
|
||
