| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
FIGURE 4-12. Installing Injector Sleeve O-Ring.
CAUTION
Do not hit the driver with a hammer.
(b)
Use the injector Sleeve Driver to push the sleeve into the bore.
(c)
Remove the driver from the sleeve.
(d)
Install the injector sleeve holding tool into the sleeve. Tighten the
capscrew to 35 to 40 ft-lb. torque.
(e)
Install the driver in the sleeve.
(f)
Hit the driver two times with a hammer to make sure the sleeve is
against the bottom of the bore.
(g)
Remove the driver and tighten the holding tool capscrew again to 35 to
40 ft-lb. torque.
(h)
Use the Injector Sleeve Expander to expand the upper section of the
sleeve to cause a seal between the sleeve and the cylinder head.
CAUTION
Be careful when you expand the sleeve. Do not damage the sleeve and O-ring.
1
Install the expander into the sleeve. Use an inch-pound torque wrench
to turn the mandrel of the expander.
2
Turn the mandrel until the torque wrench shows 75 in-lb. torque.
4-24
|
||
|
||
