| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
SECTION IV. REMARKS BOWTHRUSTER ENGINE
REFERENCE
REMARKS
CODE
A
Depot maintenance will be performed on a case by case basis subject to approval and
funding by the National Maintenance Point (NMP).
B
This item is a candidate for direct exchange with the vendor.
C
During disassembly of the engine, put a cover tape over the inset and outlet of the
turbocharger.
D
Remove the capscrews in the opposite sequence as that used for installing the cylinder
heads
E
When a flanged locknut is used to hold the pulley on the shaft, you must not let the
accessory drive shaft turn when the locknut is removed. When the flanged locknut is
installed, it is tightened to 270 to 340 ft. lbs. torque.
F
Do not use a hammer or screwdriver to remove the caps from the connecting rods.
G
Do not use a hammer or other tools to remove the piston pin.
H
You do not need to use shims for the cylinder liner unless the counterbore has been
repaired.
I
Inspect the cylinder block on a flat surface to prevent distortion. Do not inspect the
cylinder block on the engine stand.
J
Repair of this item is by replacement.
Change 3
B-20
U.S. GOVERNMENT PRINTING OFFICE: 1994-555-028/00227
|
||
|
||
