| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-9
(b) Remove eight capscrews and lockwashers (3). Remove reservoir cover (4).
(c) Remove suction strainer (11, 14) from metallic pipes (10, 13) inside the reservoir attached to porting
blocks (9, 12).
(d) Remove both low level sensors (39) from interior of reservoir.
(e)
Remove six shutoff valves (40) from bottom of drip trays.
(2) Hydraulic Piping.
(a) Place utility pail under all tube fittings to be disconnected.
(b) Disconnect tube fitting (22) from pump (21) and tube fitting (16) from porting outlet left block (15).
(c) Remove clamp assembly (17). Remove inlet tubing (18).
(d) Disconnect tube fitting (20) from pump (21) and tube fitting (45) at port uniblock 2A assembly (44).
Remove outlet tubing (19).
(3) Gauges.
(a) Tag and disconnect and remove electrical connector cable clamp (24), terminal connectors (25),
cable sheathing (26), and wire (27) from uniblock 2A assembly (44). Remove dial indicating
pressure gauge (28) and dial indicating vacuum gauge (46).
(b) Remove two hexhead capscrews and lockwashers (36, 37). Lift port uniblock 2A assembly (44) up
and remove gasket (38).
b. Pumpset (Starboard Assembly Looking Aft).
Reservoir cover disassembly is performed in DISASSEMBLY
paragraph a(1).
(1) Hydraulic Piping.
(a) Place utility pail under all tube fittings to be disconnected.
(b) Disconnect tube fitting (34) from pump (35) and tube fitting (7) from porting outlet left block (8).
(c) Remove clamp assembly (6). Remove inlet tubing (5).
(d) Disconnect tube fitting (2) from pump (35) and tube fitting (42) at starboard uniblock 2A assembly
(43). Remove outlet tubing (1).
(2) Gauges.
(a) Tag and disconnect and remove electrical connector cable clamp (32), terminal connectors (29),
cable sheathing (30), and wire (31) from uniblock 2A assembly (43). Remove dial indicating
pressure gauge (33) and dial indicating vacuum gauge (41).
2-25
|
||
|
||
