| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-9
Section III. TOOLS AND TEST EQUIPMENT REQUIREMENTS
FOR
STEERING GEAR
(1)
(2)
(3)
(4)
(5)
Tool or Test
Equipment
Maintenance
National/NATO
Tool
Ref Code
Category
Nomenclature
Stock Number
Number
1
C, O, F, H
Tool Kit, General Mechanics
(50980) SC-5180-
90-CL-N05
2
H
Tool Kit, Oil Condition
3
O, H
Tool Kit, Electricians
(80064)
9000S6202-
73125ALT2
Section IV. REMARKS
FOR
STEERING GEAR
Reference
Code
Remarks
A
VISUALLY INSPECT FOR OBVIOUS DEFECTS SUCH AS LOOSE / DAMAGED
COMPONENTS AND FLUID LEAKS.
B
OPERATIONAL TEST - OBSERVE FLUID SITE GAGE LEVEL, OIL FILTER
CONDITION
AND HYDRAULIC PRESSURE.
C
ALL WELD REPAIR WILL BE DONE AT GS LEVEL.
D
LUBRICATE OR ADD OIL.
E
FUNCTION TO BE PERFORMED IN DRYDOCK FACILITIES.
F
USE APPROPRIATE TOOLS AND TECHNICAL DATA AT DEPOT OR CONTRACTED
REPAIR ACTIVITY TO EFFECT OVERHAUL.
G
CHECK BEARING TEMPERATURE WITH THERMOMETER AND NOT BY HAND. IF
BEARINGS ARE RUNNING HOT (OVER 180 DEG.), THE CONDITION MAY BE THE
RESULT OF TOO MUCH LUBRICANT. IF CHANGING LUBRICANT DOES NOT
CORRECT CONDITION, REPLACE MOTOR.
H
NOT REPLACED AS A UNIT. REPLACEMENT IS BY INDIVIDUAL COMPONENTS
I
LIMITED REPAIR AT DS / GS LEVEL. WHEN REPAIR I IN-DEPTH REPAIR IS
REQUIRED,
REFER TO THE NATIONAL MAINTENANCE POINT (NMP) FOR INSTRUCTIONS /
APPROVAL.
J
COMPLETE REPAIR / IN-DEPTH REPAIR TO BE PERFORMED BY THE
MANUFACTURER.
K
REPAIR OF THIS ITEM IS BY REPLACEMENT.
L
DEPOT LEVEL REPAIR / MAINTENANCE WILL BE PERFORMED ON A CASE BY
CASE
BASIS SUBJECT TO APPROVAL AND FUNDING BY THE NATIONAL MAINTENANCE
POINT (NMP).
Change 3 B-6
|
||
|
||
