| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0026 00
Connect to Shore Power (continued)
WARNING
The shore power cable is configured with a pigtail on the shore end of the cable. Ensure
that the pigtail is wired to the shore source in accordance with the CFR and with all
applicable local codes and regulations. Failure to properly wire the pigtail can result in
equipment damage, serious injury, or death.
! CAUTION
The LCM-8 Mod 2 shore power system is designed to operate on 220 Volt, 60 Hz, single
phase power only. Ensure that this power standard is available prior to connecting the
shore power cable. Failure to comply can result in equipment damage.
5.
Connect the pigtail end of the shore power cable to a 220 Vac, 60 Hz, single phase shore power source. When connecting
the shore power cable pigtail, ensure that the wires are connected green-to-green, black-to-black, and white-to-white. If
the source wires are not colored green, black, and white, consult the custodian of the shore power source to determine
the proper wiring scheme. On the LCM-8 Mod 2 shore power pigtail, the following color scheme applies:
a.
Green--ground
b.
Black--neutral
c.
White--hot
6.
Connect the vessel end of the shore power cord to the LCM-8 Mod 2's shore power plug.
7.
Set to ON the shore power at its source.
8.
Observe that the SHORE POWER indicator light is illuminated on the shore power transfer panel.
9.
Set to the SHORE POWER position the shore power transfer switch (83).
10. Set to ON the 220 Volt and 110 Volt circuit breakers (82) as required by operating conditions.
DISCONNECT SHORE POWER
1.
Set to OFF all of the circuit breakers (82) in the 220/110 Volt distribution box.
2.
Set to OFF the shore power at its source.
3.
Set to the GENERATOR position the shore power transfer switch (83).
4.
Disconnect the shore power cable from the vessel's shore power plug.
5.
Disconnect the shore power cord from the shore power source.
6.
Stow the shore power cord.
0026 00-29
|
||
|
||
