| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0077 00
REMOVAL--WIPER BLADE (continued)
! CAUTION
Do not allow the wiper arm to come in contact with the windshield. Unprotected contact
between the wiper arm and the windshield can scratch the windshield.
3.
If the wiper arm (4) must be released, place a clean wiping rag between the arm and the windshield to prevent windshield
damage.
INSTALLATION--WIPER BLADE
1.
Position the wiper blade (3) in its slot on the wiper arm (4) and align the bolt holes.
NOTE
Do not overtighten the wiper blade attaching bolt and nut. The wiper blade must be free
to pivot in the wiper arm in order to properly wipe the windshield.
2.
Secure the wiper blade (3) to the wiper arm (4) with the bolt (1) and nut (2).
REMOVAL--WIPER ARM
WARNING
Replace or repair units only after the affected circuit has been secured, locked out, and
tagged out. Performing replacement with the circuit energized may result in damaged
equipment and serious injury or death.
1.
Remove the bolt (5) that secures the slave arm (6) to the slave arm shaft (7).
2.
Remove the bolt (8) that secures the wiper arm (4) to the wiper motor shaft (9).
3.
Pull the slave arm (6) and the wiper arm (4) from their mountings.
INSTALLATION--WIPER ARM
1.
Hold the wiper arm (4) in its proper position on the windshield and slide the wiper arm over the wiper motor shaft (9).
Secure it in place by tightening the bolt (8).
2.
Slide the slave arm (6) over the slave arm shaft (7) and secure it in place with the bolt (5).
0077 00-2
|
||
|
||
