| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0093 00
REMOVAL (continued)
2.
Label and disconnect the wiring connected to the negative (1) and positive (2) alternator terminals.
3.
Loosen the adjusting strap bolt (3) and the pivot bolt (4).
4.
Move the alternator (5) as necessary, and remove the drive belts (6).
5.
Remove the adjusting strap bolt (3).
6.
Remove the pivot bolt (4) and the alternator (5).
INSTALLATION
1.
Position the alternator (5) in place and install the pivot bolt (4). Do not tighten the pivot bolt (4) yet.
2.
Install the adjusting strap bolt (3) loosely.
3.
Position the alternator (5) so that the drive belts (6) may be placed over the alternator drive pulley (7).
4.
Move the alternator (5) to adjust the drive belts (6) until there is a belt deflection of approximately 1/2 inch (13 mm)
measured midway between the alternator drive pulley (7) and the crankshaft pulley.
5.
Tighten the adjusting strap bolt (3) and recheck the belt tension. If the tension is acceptable, proceed to the next step.
If the tension is not acceptable, loosen the adjusting strap bolt (3) and readjust the belt's tension.
6.
Tighten the pivot bolt (4).
7.
Connect the wiring to the positive (2) and negative (1) alternator terminals using the labels from step 2 of Removal as a
guide.
8.
Remove the lockouts and tagouts, set to ON the battery isolation switches, and test the alternator as described in
END OF WORK PACKAGE
0093 00-2
|
||
|
||
