| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0197 00
INSPECTION (continued)
3.
Inspect the hand grip for deterioration. Replace the hand grip as required.
4.
Replace all packing, O-rings, and seals with new parts.
5.
Remove burrs or nicks with crocus cloth.
ASSEMBLY
1.
Wrap the pipe plug (33) threads with antiseizing sealant tape and install the pipe plug in the pump body (20).
2.
Install the O-rings (28 and 29) and backup ring (30) on the check valve seat (27). Lubricate the O-rings with clean
hydraulic fluid.
3.
Install the check valve seat (27), ball check valve (31), and spring (32) into the plunger (9).
4.
Install the O-rings (23 and 24) and backup rings (25 and 26) on the bushing (22). Lubricate the O-rings with clean
hydraulic fluid.
5.
Slide the bushing (22) over the plunger (9).
6.
Install the plunger (9) assembly into the pump body (20) and secure it with the retaining ring (21).
7.
Install the O-rings (14, 16, and 17) and backup ring (15) on the inlet oil fitting (13). Lubricate the O-rings with clean
hydraulic fluid.
8.
Install the spring (19), ball check valve (18) and inlet oil fitting (13) into the pump body (20).
9.
Install the O-ring (11) on the bleeder screw (10). Lubricate the O-ring with clean hydraulic fluid.
10. Install the ball (12) and bleeder screw (10) in the pump body (20).
11. Position the hand pump operating lever (3) in the plunger (9) and secure it with the retaining rings (6), clevis pins (7), and
link (8).
12. Position the hand pump operating lever (3) in the pump body (20) and secure it with the clevis pin (5) and retaining
rings (4).
13. Install the pump handle grip (1) on the hand pump operating handle (2) if the grip was removed.
14. Install the hand pump operating handle (2) in the hand pump operating lever (3).
15. Dispose of used hydraulic fluid, cleaning solvent, and contaminated materials in accordance with local regulations.
END OF WORK PACKAGE
01970197 00-3
00-3/4 blank
|
||
|
||
