| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0200 00
INSTALLATION--PROPELLER SHAFT
1.
Using two crewmembers, slide the propeller shaft (2) into place through the strut (15) and stern tube (10).
2.
Apply a light coat of antiseize compound on the propeller shaft (2) taper.
3.
Install the key (14) and shaft coupling (9) on the propeller shaft (2).
4.
Secure the shaft coupling (9) to the propeller shaft (2) with the washer (13), hex nut (12), and cotter pin (11).
5.
Align the propeller shaft (refer to WP 0202 00).
6.
Secure the shaft coupling (9) to the the marine transmission with the bolts (7) and nuts (8).
7.
Remove the lockouts and tagouts and check the operation of the system.
REMOVAL--CUTLESS BEARING
1.
Perform the Removal--Propeller and Removal--Propeller Shaft procedures in this work package.
2.
Remove the capscrews (16) that secure the cutless bearing (17) in the strut (15).
3.
Loosen the bolts (18) that secure the upper and lower strut castings.
4.
Remove the cutless bearing (17) from the strut (15).
15
16
17
18
16
0200 00-3
|
||
|
||
