| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0206 00
DISASSEMBLY (continued)
4.
Remove the screws (8) from the cover (7). Separate the cover from the body (2).
5.
Remove the spring (9) and pressure plate (10) from the body (2).
6.
Matchmark the cam ring (11) to the body (2) by lightly scribing the outside face of the cam ring. Remove the cam ring,
pins (12), rotor (13), vanes (14), and O-rings (15 and 16) from the body.
7.
Clamp the cover (7) in the vise. Use protective jaws. Drive out the retaining pin (17) with a pin punch.
8.
Remove the plug (18), O-ring (19), control valve (20), and spring (21) from the cover (7).
9.
Remove the retaining ring (22) from the body (2).
10. Remove the shaft (23) and bearing (24) from the body (2) as an assembly.
11. Remove the woodruff key (25) from the shaft (23).
12. If the bearing (24) will not be replaced, do not remove it from the shaft (23). If the bearing will be replaced, remove the
retaining ring (26) from the shaft and press the bearing off the shaft.
13. Gently tap the shaft seal (27) from the body (2).
14. If the needle bearing (28) will not be replaced, do not remove it. If the needle bearing will be replaced, gently tap it out
of the body (2).
22
25
23
24
26
27
28
2
16
1
15
3
13
11
5
4
10
6
14
9
7
12
17
20
18
21
8
19
0206 00-2
|
||
|
||
