| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0209 00
INSPECT
1.
Inspect threaded parts for thread damage.
2.
Inspect identification plates for legibility and for secure mounting.
3.
Check the springs for distortion or loss of tension.
4.
Inspect the spools for burrs or scoring.
5.
Inspect the spring stop and seat for wear.
6.
Replace all packing and gaskets.
ASSEMBLY
1.
Install the check spool seat (25) in the body (26).
2.
Install the screw (24) in the body (26).
3.
Install the check spool (23), spring stop and seat (22), and main spool (21) into the body (26).
4.
Install the preformed packing (18, 19, and 20) and the check spring (17) into the body (26).
5.
Position the bottom cap (15) onto the body (26) and secure it with the screws (16).
6.
Install the plug (14) and pipe plug (13) into the bottom cap (15).
7.
If removed, install the adjusting knob (11) onto the adjusting screw (8) and secure it with the setscrew (12).
8.
If removed, install the identification plate (10) onto the adjusting knob (11) with the drive screws (9).
9.
If removed, install the locknut (7) onto the adjusting screw (8) and insert the adjusting screw and attached parts into the
top cap (2).
10. Install the preformed packing (6) into the spring follower (5) and install the spring follower and main spring (4) into the
top cap (2).
11. Position the gasket (3) and top cap (2) on the body (26) and secure them with the screws (1).
12. Dispose of used cleaning solvent and contaminated materials in accordance with local regulations.
END OF WORK PACKAGE
02090209 00-3
00-3/4 blank
|
||
|
||
