| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0216 00
ASSEMBLY--BEARINGS AND SEALS TO DRUM (continued)
10. Install the bearing (58) on the splined end of the drum (52) so that the snap ring (57) on the bearing is installed towards
the drum.
11. If removed during disassembly, press the bushing (56) in the drum (52) using a sizing mandrel that is 2.1885 inches in
diameter. Install the drum bushing so that the end of the drum bushing is flush with the end of the drum.
ASSEMBLY--DRUM INTO THE WINCH BASE
1.
Using additional personnel or a suitable lifting device, place the winch base (62) on the work bench so that the side that
is to be the final drive end of the winch is facing up.
2.
Attach the final drive housing (3) to the winch base (62) using the dowel bolts (4), lockwashers (2), and nuts (1).
3.
Using additional personnel or a suitable lifting device, turn this assembly over so that it rests on the end of the final drive
housing (3).
4.
Using additional personnel or a suitable lifting device, take the assembled drum (52) and pilot the bearing (58) on the
splined end of the drum into the bore of the final drive housing (3). Tap the drum assembly down until the snap ring (57)
on the bearing at the splined end of the drum is properly seated on the end of the final drive housing bore. There will be
approximately 1/16 inch clearance between the final drive housing and the end of the drum flange when the bearing snap
ring is seated.
5.
Torque the nuts (1) to 75 lb-ft (102 Nm).
ASSEMBLY--BRAKE HUB ASSEMBLY
1.
Place the sun gear (47) splined end down, on a clean work surface.
2.
Install a spacer (45) on the sun gear (47).
3.
Install a snap ring (50) in the bore of the brake hub (44).
4.
Place the brake hub (44) over the sun gear (47) so that it rests on the spacer (45).
5.
Take 28 camlocks (49) and assemble them so that they stand on end between the sun gear (47) and the bore of the brake
hub (44) as shown below.
47
44
0216 00-10
|
||
|
||
