| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0226 00
Explanation of Columns in the MAC (continued)
Column (4) - Maintenance Level. Column (4) specifies each level of maintenance authorized to perform each function listed
in column (3), by indicating work time required (expressed as manhours in whole hours or decimals) in the appropriate
subcolumn. This work time figure represents the active time required to perform that maintenance function at the indicated
level of maintenance. If the number or complexity of the tasks within the listed maintenance function varies at different
maintenance levels, appropriate work time figures are to be shown for each level. The work time figure represents the average
time required to restore an item (assembly, subassembly, component, module, end item, or system) to a serviceable condition
under typical field operating conditions. This time includes preparation time (including any necessary disassembly/assem-
bly time), troubleshooting/fault location time, and quality assurance time in addition to the time required to perform the
specific tasks identified for the maintenance functions authorized in the MAC. The symbol designations for the various
maintenance levels are as follows:
C - Operator or crew maintenance
O- Unit maintenance
F - Direct support maintenance
H - General support maintenance
D - Depot maintenance
Column (5) - Tools and Equipment Reference Code. Column (5) specifies, by code, those common tool sets (not individual
tools), common Test, Measurement and Diagnostic Equipment (TMDE), and special tools, special TMDE and special
support equipment required to perform the designated function. Codes are keyed to the entries in the tools and test equip-
ment table.
Column (6) - Remarks Code. When applicable, this column contains a letter code, in alphabetical order, which is keyed to
the remarks table entries.
Explanation of Columns in the Tools and Test Equipment Requirements
Column (1) - Tool or Test Equipment Reference Code. The tool or test equipment reference code correlates with a code used
in column (5) of the MAC.
Column (2) - Maintenance Level. The lowest level of maintenance authorized to use the tool or test equipment.
Column (3) - Nomenclature. Name or identification of the tool or test equipment.
Column (4) - National Stock Number (NSN). The NSN of the tool or test equipment.
Column (5) - Tool Number. The manufacturer's part number, model number, or type number.
Explanation of Columns in the Remarks
Column (1) - Remarks Code. The code recorded in column (6) of the MAC.
Column (2) - Remarks. This column lists information pertinent to the maintenance function being performed as indicated in
the MAC.
END OF WORK PACKAGE
0226 00-3/4 blank
0226 00-3
|
||
|
||
