| Tweet |
Custom Search
|
|
|
||
 Operation
Open valve
Close valve
Procedure
To pump 395-gal. dirty L. O. tank
(14)
(13)
Remove cap from discharge connection and
into containers using standby
(17)
(11)
connect discharge hose. Press starter
pump.
(2)
(20)
button on lubrication oil standby pump.
(1)
(16)
When tank is empty, stop pump and
(3)
close all valves. Disconnect discharge
hose and replace cap.
NOTE
Do not pump lubricating oil overboard.
To pump 50-gal. sludge tank into
Turn pump handle in clockwise direction.
containers using hand pump.
Take soundings of the sludge tank. When
the tank is empty, stop pumping.
NOTE
Do not pump lubricating oil overboard.
Normal operation, engine running.
(5)
(18)
When engine is secured, keep valves in same
(22)
(19)
position as when engine is running.
(23)
(20)
(9)
(1)
(11)
(2)
(14)
(16)
(17)
(4)
(3)
(15)
(12)
(21)
(6)
(7)
(8)
Lubricating oil standby pump
(16)
(17)
Start lubrication oil standby pump. Secure
operation, engine running.
(3)
(2)
when finished.
To operate puri-filter.
(12)
(21)
Start standby pump to circulate lubrication oil
(10)
(2)
through puri-filter. Secure pump and
(9)
(3)
valves when finished.
(11)
(20)
(14)
NOTE
(17)
Puri-filter is only used from 8 to 12
(13)
hours as required each day. For
(15)
operation, refer to paragraph 2-13c.(5)
(a).
To drain purl-filter filter into con-
(21)
(12)
When finished with purl-filter. drain residue
tainer.
container.
c. Lubricating Oil System Pump Operation.
(2) Hand rotary pump.
(a) The hand rotary oil pump is of 10-gpm
(1) Lubricating oil transfer pump.
capacity, located on port side of engine room on the forward
(a) This transfer pump has a capacity of 3
bulkhead and may be used to pump oil into a container, or to
gpm; is an electric motor driven rotary type, and is located on
the deck connection.
port side of engine room at the forward bulkhead. Purpose of
(b) Align lubricating oil system as described in
this pump is to move oil from the propulsion engine dirty oil
tank, through the purifier.
(c)
Start pumping by turning handle in a
NOTE
clockwise direction.
This pump may be referred to as the
(d) Secure by stopping handle, then return
scraper ring oil Pump.
valves moved in step (b) above to their original position.
(b) Align lubricating oil system as described in
(3) Lubricating oil standby pump.
(a) This pump is located on port side of
(c) Press START button on controller.
engineroom and may be used to supply oil with pressure to
(d) Secure the pump by pressing STOP button
the propulsion engine, while engine oil
on controller, then close valves opened in step (b) above.
2-30
|
||
|
||
