| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-204-12
Figure 5-102. Motor removal and belt adjustment.
e. Switch Replacement and Adjustment.
d. Air Intake Silencer.
(1) Replacement of snap switch.
tape which filters the intake air going to the compressor. The
(a) Remove pressure switch cover screws and
filter removes all dust from the air, thus, prolonging the life of
lift off cover.
the compressor.
(b) Disconnect electrical connections from snap
(2) Maintenance and adjustment.
switch. Mark for reassembly.
(a) Keep filter silencer clean.
(c) Remove. snap switch mounting screws.
(b) Remove filter silencer by removing nut on
(d) Installation is in reverse order of removal.
end of silencer and withdrawing silencer from silencer stud.
(2) Replacement of pressure switch assembly.
(c) Clean filter screen with compressed air. If
filter is extremely dirty wash in soapy water solution, rinse off
WARNING
with fresh water and allow to dry thoroughly prior to replacing.
Do not attempt to replace pressure switch
(d) Replace filter silencer on compressor.
with air pressure on system. Shut off air
valves at tanks.
WARNING
Never clean the filter silencer with
(a) Slowly back off coupling nut at air line
gasoline or other explosive materials.
connection to pressure switch and allow residual air in gage
and switch line to bleed off.
(b) Disconnect air line from pressure switch.
5-140
|
||
|
||
