| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0001 00
LIST OF ABBREVIATIONS/ACRONYMS (continued)
Abbreviation/Acronym
Name
t
tonne (metric)
TACSAT
Tactical Satellite
TAMMS
The Army Maintenance Management System
TFT
Thin Film Transistor
TLI
Tank Level Indicator
TMDE
Test, Measurement, and Diagnostic Equipment
TV
Television
UHF
Ultra High Frequency
UPS
Uninterruped Power Supply
USCG
United States Coast Guard
UVA
Ultrasonic Vibrator Assembly
Vac
Volts, Alternating Current
VCR
Video Cassette Recorder
Vdc
Volts, Direct Current
VHF
Very High Frequency
VICS
Vessel Information and Communication System;
Vehicular Interface Control Station
W
Watt(s)
WWS
Water Washdown System
WDCM
Washdown Counter Measure
XMTR
yd
Yard(s)
QUALITY OF MATERIAL
Material used for replacement, repair, or modification must meet the requirements of this manual. If quality of material
requirements are not stated in this manual, the material must meet the requirements of the drawings, standards, specifica-
tions, or approved engineering change proposals applicable to the subject equipment.
SAFETY, CARE, AND HANDLING
The following procedures should be observed when handling all Electrostatic Discharge (ESD) sensitive components and
units containing such components. Failure to observe all of these precautions can cause permanent damage to the electro-
static device. This damage can cause the device to fail immediately or at a later date when exposed to an adverse environ-
ment.
1.
Turn off and /or disconnect all power, signal sources, and loads used with the unit.
2.
Place the unit on a grounded, non-conductive work surface.
3.
Ground the repair operator using a non-conductive wrist strap or other device using 1 megaohm series resistor to protect
the operator.
4.
Ground any tools (including soldering equipment) that will contact the unit. Contact with the operator's hand provides
a sufficient ground for tools that are otherwise electrically isolated.
0001 00-5
|
||
|
||
