| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0013 00
4.
Wall locker (figure 5, item 4). The wall locker provides storage for tools and equipment.
5.
Cabinet (over) (figure 5, item 5). The cabinet provides storage space.
6.
Bench grinder (figure 5, item 6). The grinder is used for tool sharpening and various equipment repairs.
7.
Arc welder (below) (figure 5, item 7). The arc welder is used for repair of the vessel's equipment.
8.
Drill press (figure 5, item 8). The drill press is used for drilling holes for repair of the vessel's equipment.
9.
Workbench (figure 5, item 9). The workbench is used as a work area for repair of defective units and components.
10. Space heater (figure 5, item 10). This heater provides heat for the workshop and AMS 2 compartment.
11. Pipe vise (figure 5, item 11). The hinged jaw pipe vise is used for holding equipment or components during repairs.
12. Vent hood (figure 5, item 12). The vent hood and exhaust fan remove air and fumes from the workshop area during
welding operations.
13. Bench vise (figure 5, item 13). The bench vise is used for holding equipment or components during repairs.
14. Vent hood exhaust fan controller (figure 5, item 14). The vent hood exhaust fan controller turns the exhaust fan ON and
OFF.
15. Cabinet (figure 5, item 15). The cabinet provides storage for tools and equipment.
END OF WORK PACKAGE
00130013 00-9
00-9/10 blank
|
||
|
||
