| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0046 00
Table 23. Welder (refer to figure 23) (continued)
Key
Control/Indicator
Function
9
POWER OFF Pushbutton
Push this button to turn the welder OFF.
10
SPOT TIME
Not used.
11
Blank
This is a blank switch position for installation of optional equipment.
12
CB1 Circuit Breaker
This provides overload protection for the control circuitry.
13
OUTPUT SELECTOR Switch
This selects mode of operation without changing welding cables.
14
Door
The door protects internal components from dirt.
15
ELECTRODE Weld
This is the connector for attachment of the electrode cable.
Output Terminal
16
WORK Weld Output Terminal
This is the connector for attachment of the work cable.
17
Gas In Fitting
Not used.
18
Gas Out Fitting
Not used.
19
RANGE SELECTOR Switch
This switch selects the amperage range.
20
Duplex Receptacle
This provides up to 15A of 120 Vac for accessory or other equipment.
21
Circuit Breaker
This provides overload protection for the duplex receptacle.
22
REMOTE
Not used.
23
HIGH FREQUENCY Switch
This is a three position switch. In the START position, high frequency is
present until an arc is established. In the OFF position, high frequency is
not present. In the CONTINUOUS position, high frequency is always
present.
0046 00-33
|
||
|
||
