| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0072 00
1
3
2
4
Figure 9. EOS Console
16. On the EOS console, place the STBD MN ENG THROTTLE/CLUTCH lever (figure 9, item 2) in the NEUTRAL
(straight UP) position.
17. At the starboard main engine control panel:
a.
Press the CONTROL POWER pushbutton (figure 4, item 2), and verify that the CONTROL POWER indicator
(figure 4, item 3) is illuminated.
NOTE
Main engine start normally includes a 60-second operation of the turbo lube oil pump prior to
starting the engine. However, in an emergency, the engine may be started without delay.
b.
Momentarily press and release the ENGINE START pushbutton (figure 4, item 4) to start the turbocharger lube oil
pump.
c.
Verify that the ALARM TEST indicator (figure 4, item 5) is illuminated.
d.
Verify that the power ON indicator (figure 4, item 6) is illuminated.
e.
Verify that the ALARM OFF indicator (figure 4, item 7) is illuminated.
f.
Verify that the START AIR pressure gauge (figure 4, item 8) indicates approximately 200 PSI (13.8 bar).
18. On the EOS console, verify that the CONTROL AIR PRESSURE gauge (figure 9, item 3) indicates approximately 125
PSI (8.6 bar).
19. Ensure that the shaft brake pressure gauge (figure 2, item 4) indicates 1200 to 1500 PSI (82.7-103.4 bar).
20. Open the engine top deck covers (figure 2, item 5) and check that the valve train is receiving adequate flow from the
prelube pump. If the flow is adequate, close the engine top deck covers. If the flow is inadequate, notify unit mainte-
nance.
21. Blow down the starboard main engine by performing the following steps:
a.
OPEN the test valves (figure 10, item 1) on both sides of the starboard main engine, approximately inch.
0072 00-7
|
||
|
||
