Figure 3. Main Switchboard - TM-55-1925-273-10-10811

Custom Search

Table 2. Sump Fill Alignment (Refer to Figure 1 for Valve Locations) (continued)

TM-55-1925-273-10-1 Inland and Coastal Large TUG (LT) NSN 1925-01-509-7013 (EIC XAG) Manual

Figure 4. 440V Power Panel No. 1

TM 55-1925-273-10-1

0073 00

! CAUTION

Do not overfill the engine lube oil sump. Overfilling the sump can cause damage to the engine

oil seals.

Align the electrical system, and start the transfer pump to fill the sump with lube oil by completing the following

actions:

At the main switchboard in the EOS, verify that the ENGINE ROOM PWR PNL NO.1 circuit breaker (figure 3,

item 1) is set to ON.

In the engine room on the aft bulkhead of the EOS, at 440V power panel No. 1, set the LUBE OIL TRANSFER

PUMP circuit breaker (figure 4 item 1) to ON.

In the engine room, at the lube oil transfer pump motor controller:

(1)

Set the ON-OFF switch (figure 5 item 1) to ON.

(2)

Verify that the POWER AVAILABLE indicator (figure 5, item 2) energizes.

(3)

Press the motor controller START pushbutton (figure 5, item 3).

(4)

Verify that the MOTOR RUN indicator (figure 5, item 4) energizes.

Figure 3. Main Switchboard

0073 00-5