| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0079 00
a.
Oily bilge transfer pump strainer differential pressure gauge reads between 0 and 15 PSI (0 to 1.03 bar).
b.
Oily bilge transfer pump discharge press gauge reads between 0 and 20 PSI (0 to 1.39 bar).
6.
When the bilge is empty, stop the pump by placing CA-56, COV OILY BILGE PMP SUCT in the CLOSED position.
7.
CLOSE the suction valve for the bilge that was pumped.
TRANSFER OILY WATER FROM DRAIN TANK TO STORAGE TANK
1.
OPEN OB-7, OILY DR. TK. SUCT (figure 9, item 11), oily waste drain tank suction.
! CAUTION
The air supply regulator pressure gauge should not read above 90 PSI (6.21 bar) or damage
could occur to the pump.
2.
Start the pump by placing CA-56, COV OILY BILGE PMP SUCT in the OPEN position.
3.
Verify the readings at the following gauges:
a.
Oily bilge transfer pump strainer differential pressure gauge reads between 0 and 15 PSI (0 to 1.03 bar).
b.
Oily bilge transfer pump discharge press gauge reads between 0 and 20 PSI (0 to 1.39 bar).
4.
When the bilge is empty, stop the pump by placing CA-56, COV OILY BILGE PMP SUCT in the CLOSED position.
5.
CLOSE OB-7, OILY DR. TK. SUCT (figure 9, item 11), oily waste drain tank suction.
PUMP CONTENTS OF TANKS TO SHORE
1.
Make a connection to the shore facility with the oily waste shore connection.
2.
Align the piping system as follows:
a.
OPEN the following valves:
(1)
OB-22, C.O.V. SHORE CONN oily waste shore connection cutoff, located on the main deck
(2)
OB-9, OILY BILGE PMP. DISCH TO SHORE (figure 9, item 8), oily bilge pump discharge to shore connec-
tion
b.
CLOSE OB-8, OILY BILGE PMP DISCH. TO OILY WST.STOR. TK. (figure 9, item 18), oily bilge pump dis-
charge to the oily waste storage tank.
3.
Align the selected tank to pump to shore as follows:
NOTE
Pump the contents of one tank at a time.
a.
To pump the oily waste drain tank, position the valves as follows:
(1)
OPEN OB-7, OILY DR. TK. SUCT (figure 9, item 11), oily waste drain tank suction.
0079 00-15
|
||
|
||
