| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0086 00
5.
Press the MODE button (figure 2, item 3) and the down arrow button (figure 2, item 4) on the LMI receiver panel (figure
2, item 2) to select the load preset selection screen (figure 20).
6.
Press the up arrow button (figure 2, item 5) or the down arrow button (figure 2, item 4) on the LMI receiver panel (figure
2, item 2) until TARE is highlighted.
7.
Press the MODE button (figure 2, item 3) and the down arrow button (figure 2, item 4) on the LMI receiver panel (figure
2, item 2) to return to the primary operating display (figure 10). The primary operating display will show the letter T
(figure 31, item 1).
Angle= 45.0 deg MAIN= 15,000lbs
MaxLoad
Radius= 42.0 ft
81% T8500lb
1
Figure 31. Primary Operating Display Screen with Tare Enabled
DISABLE LOAD TARE OUT FUNCTION
NOTE
Increasing or decreasing crane the boom angle by 3 degrees will disable the TARE OUT
function.
1.
Increase or decrease the crane boom angle by three degrees.
2.
Disabling of the TARE OUT function is complete.
LOAD MOMENT INDICATOR (LMI) SHUTDOWN
1.
Ensure that any minimum and/or maximum alarm settings have been returned to their desired readiness condition.
2.
Set to OFF the CRANE LOAD circuit breaker (figure 1, item 1) on the 24V machinery DC control distribution panel
(figure 1, item 2) in the engine room.
CRANE OPERATION
1.
Perform the Central Hydraulic System Hydraulic Power Unit (HPU) Startup procedure (WP 0076 00).
2.
Perform the Load Moment Indicator (LMI) Startup procedure in this work package.
0086 00-15
|
||
|
||
