| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0091 00
3
4
1
PULL
2
5
6
Figure 19. Trash Compactor
BEVERAGE DISPENSER
1.
At the 220/110V distribution panel, set the BEVERAGE DISPENSER. circuit breaker (figure 10, item 6) to ON.
2.
To set up the beverage dispenser, perform the following steps:
a.
Install the drip pan as follows:
(1)
Place the drip pan cover on top of each drip pan.
(2)
Place the top edge of the drip pan under the lip on the front panel.
(3)
Lower each drip pan enough that the alignment tab goes into the tab slot and locks the pan into place.
b.
Assemble the bowl as follows:
(1)
Place the bowl (figure 20, item 1) upside down on the counter.
NOTE
Both the bowl and the gasket must be dry. If wet, beverage could leak out.
(2)
Place the bowl gasket over the neck of the large opening on the bottom of the bowl (figure 20, item 1).
(3)
Place the bowl (figure 20, item 1) right side up, with the bowl gasket centered on the cooling plate and the
guide pin.
(4)
Grasp the bowl (figure 20, item 1) by opposite corners and with downward pressure and twisting motion, set
the bowl (figure 20, item 1) into position.
0091 00-25
|
||
|
||
