| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0091 00
3
1
1
4
Y F
RAOF
SP
ON
IG F
FR OF
RE
ON
5
2
Figure 20. Beverage Dispenser
NOTE
Ensure that the bowl is square to front of the unit, with the handle bracket in front over the drip
pan. If necessary, use a touch of cornstarch to lubricate the gasket for easier assembly.
There are flat surfaces on the guide pin. Turn the bearing sleeve until the sleeve aligns with the
guide pin and drops into place. The flange on the bearing sleeve must rest flush on the cooling
plate.
(5)
Place the bearing sleeve over the guide pin in the middle of the cooling plate.
(6)
Place the impeller on the bearing sleeve (fin side up).
NOTE
The top of the spray tube is "pinched" and bent. The "pinched" and bent top end of tube is to be
pointed toward the front of the bowl. A 3/8-inch tab on the front of the pump cover, near the spray
tube sleeve, goes between the two locator notches on the bowl.
(7)
Press the spray tube into the sleeve on top of the pump cover.
(8)
Place the pump cover over the guide pin, keeping the spray tube toward the front of the unit and centered in
the bowl.
(9)
Install the lock washer on the guide pinhead until the guide pin neck is completely in the keyway.
c.
Assemble the valve and handle by performing the following steps:
0091 00-26
|
||
|
||
