| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-2
0120 00
3.
Check that the starboard main engine oil is at the normal level on the dipstick (figure 2, item 1). If the engine oil level
is low, add oil until the proper level is achieved. Refer to TM 55-1925-208-24 or maintenance supervisor for oil
specification.
4.
Check that the starboard reduction gear oil is at the normal level on the dipstick (figure 2, item 2). If the reduction oil
is level low, add oil until the proper level is achieved. Refer to TM 55-1925-223-24&P or maintenance supervisor for
oil specification.
5.
At 440V power panel No. 1, set the following circuit breakers to ON:
a.
FRESH WATER PUMP No. 1, (REDUCTION GEAR). (figure 3, item 1)
b.
MAIN ENGINE LUBE OIL PRIMING PUMP No. 1. (figure 3, item 2).
c.
MAIN ENGINE JACKET WATER HEATER No. 1./TURBO OIL PUMP No. 1./WATER LAY OVER PUMP No.
1. (figure 3, item 3).
6.
Allow the main engine jacket water heater to run for at least 8 hours before continuing with this procedure.
7.
OPEN valve Lo-47, C.O.V. PRELUBE PMP. DISCH. (figure 2, item 3).
8.
PUSH the START pushbutton (figure 4, item 1) for the prelube pump.
9.
At 120V emergency distribution panel No. 1, ensure that the following circuit breakers are set to ON:
5
5
7
3
6
1
5
6
4
2
Figure 2. Starboard Main Engine and Reduction Gear
0120 00-2
|
||
|
||
