| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
TOOLS: Two 7/16 inch Box Wrenches
Snap Ring Pliers
PARTS/MATERIALS: Steering Wheel Assembly
Set master switch to "OFF'. Severe burns and shocks may result.
REMOVE:
1.
Open access panel under control console (refer to paragraph 3-154).
2.
Using pliers remove snap ring (1) at forward end of hub (located beneath console).
3.
Gently slide steering wheel assembly (2) from steering gear carriage (3) and remove two-piece plastic insert (4) from
steering wheel shaft.
INSTALL:
1.
Slide new steering wheel assembly (2) into steering gear carriage (3) but do not seat fully.
2.
Place two-piece plastic insert (4 and 5) around steering wheel shaft with raised portion of upper insert (4) toward
steering wheel.
3.
Seat steering wheel assembly fully in steering gear carriage (3).
4.
Install new plastic sleeve (6) over steering wheel shaft (7).
Using pliers reinstall snap ring (1) at forward end of steering wheel shaft.
5-
6.
Close access panel.
3-91
|
||
|
||
