| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
(b) Adjust the depth of the counterbore cutter:
1
Put the bushing plate on a flat surface with the side of the plate marked "Top" away from the surface.
2
Install the counterbore cutter in the 5/8 inch (15.8 mm) bushing. Ensure the cutter is against the flat
surface.
3
Slide the stop collar up on the counterbore cutter.
4
Put the gauge block on top of the bushing plate. Hold the curve at the plate ag inst the cutter.
a
5
Slide the stop collar down against the gauge block (Figure 4-13). Tighten the setscrew in the stop collar.
6
Remove the cutter and gauge block from the bushing plate.
(c) Put the bushing plate on the cylinder head with the side of the plate marked "Top" away from the cylinder
head.
(d) Fasten the busing plate to the cylinder head. Insert the adapter screw through an injector hole and through
the bushing plate. Install the adapter knob on the end of the adapter screw.
(e) Insert the locating pin through the 5/8 inch bushing and into the water hole to be repaired. Use your hand to
tighten the adapter knob to approximately 50 ft lb (67 N ) torque.
-
m
FIGURE 4-13. Adjusting Counterbore Cutter.
4-42
|
||
|
||
