| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
c.
Install a temporary screw in the shaft (5). This will prevent breakage of the lockscrew when the plug is
installed in the housing.
d.
Apply a light coat of sealant to the expansion plug hole in each end of the housing.
(1) Use the expansion plug driver to install the expansion plug (2, FIGURE 4-17).
(2) Install the plug (2) so it is at least even with the edge of the hole or not more than 0.010 inch (0.25
mm) below the edge of the hole.
e.
Remove the temporary screws and install the lockscrews in the shafts (21).
f.
Install the cam follower housing (paragraph 3-31).
4-40
|
||
|
||
