| Tweet |
Custom Search
|
|
|
||
 -KEY-
NOTES:
1. FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW -10 F. Remove
lubricants prescribed in the key for temperatures above -10F. Relubricate with lubricants specified in the key
for temperatures below -10F.
2. OIL STRAINER. Disassemble, clean element with fuel oil, dry and re-install element.
3. OIL FILTER. Disassemble, clean housing, replace element, and reassemble. Operate engine for 5 minutes,
check oil level and fill crankcase to full mark on dipstick.
4. ENGINE CRANKCASE DRAIN. Remove plug at end of hose, pump out crankcase and replace plug. Fill
crankcase and replace plug. Fill crankcase with 28 quarts of engine oil at fill cap.
5. TRANSMISSION OIL DRAIN. Every 250 hours remove dipstick, pump out transmission sump and replace
dipstick. Fill transmission with 18 quarts of OE oil at fill cap.
6. POWER TAKEOFF CLUTCH RELEASE LEVERS AND LINK PINS. Remove inspection cover, Iubricate levers
and link pins sparingly, and install cover.
7. LUBRICANTS. The following is a list of lubricants with the Military Symbols and applicable Specification
numbers.
OE MIL-L.-2104
OES MIL.-L.-10295
GAA MIL-L.-10924
Copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are mandatory.
BY ORDER OF THE SECRETARY OF THE ARMY:
WILLIAM C. WESTMORELAND
General, United States Army,
Chief of Staff.
OFFICIAL:
VERNE L. BOWERS
Major General, United States Army,
The Adjutant General.
LO 55-1905-217-12-3 DISTRIBUTION: To be distributed in accordance with DA Form 12-25 (qty. Rqr. Block no. 813)
operator maintenance requirements for Marine Equipment: All.
GPO 824-202
|
||
|
||
