| Tweet |
Custom Search
|
|
|
||
 TB 55-1900-231-15
2. The lettering will be capital letters black in color, water proof, nonfading and durable. Letters will be
one (1) inch in height, but may reduced to conform with smaller covers. Markings will contain the
information listed in 3 below.
3. ROWPU BARGE, NO 2 EQUIPMENT COVER
SEA WINCH (1 of 4)
NAN 6675-01-230-0723
MANUFACTURER GLOBAL CHEMICAL
MFG ASSEMBLY NO. 415-DJCD-111
MFG UNIT NO. None Listed
E. Identification for each individual cover will be marked as follows:
1. Each unit of one assembly is identified for ROWPU No. 2 and one assembly for ROWPU No. 3.
2. Each cover/unit in the assembly is marked by its specific purpose, i.e. Reel covers Vent Covers.
3. All covers in sets will be further identified by set as follows Sea Winch 1 of 4, 2 of 4 etc.
4. Each cover is provided with one (1) durable set of instructions that contain step by step procedures
for closing, opening installing and the removal of the covers.
F. MAINTENANCE OF THE COVERS.
The covers are designed to provide for the protection of the machinery under all weather conditions, however
routine maintenance must be provided to keep them in an optimum condition.
1. All covers will be inspected monthly for cracks, open seams or tears and repairs made as soon as
possible.
2. All straps, and closure will be properly secured. Any damage to the straps and closures will be
repaired as soon as practical after the damage is discovered.
3. A periodic cleaning schedule will be established to maintain the covers in good condition
4. When required by the monthly inspections, the covers will be washed free of all grease, soiled
spots, and salt deposits, as follows:
(a) The soiled areas will be scrubbed with a water soluble detergent or cleaning compound.
(b) After soiled areas are scrubbed the covers will be hosed down with fresh water.
G. COVER REMOVAL AND STORAGE.
The following procedure will be accomplished when removing the covers and during activation, for
stowing them below decks.
1. All straps and securements will be opened or unlatched to prevent the cover from binding when
removed.
2. Insure that the cover does not hang up or snag on the machinery.
E-2
|
||
|
||
