| Tweet |
Custom Search
|
|
|
||
 TB 55-1900-231-15
NOTE
Fill and drain piping will be processed in conjunction with Item 5.(b) and
6.(b).
(d)
Fuel Oil Storage Tanks Nos. 1 and 2. Including fill and discharge piping, work in conjunction with Item 10.
(a). Drain and dry. Offset access covers on two studs to leave tanks open to D/H. Bag and tag the reminder
of access securements with new gaskets adjacent to the respective access, ready for assembly. Install
blanks in vents for each tank on top of deck house. Tanks are preserved with P10 Type 1 Grade 30.
(e)
Fuel Oil Day Tank - Fill day tank to 95%. Treat fuel with a stabilizer additive meeting the requirements of
MIL-S-53021. The vent for this tank will remain open. Fill and drain valves, fuel supply valves to engine will
be closed. (See Appendix G for stabilizer handling procedures).
(f)
Contaminated Oil/Sludge Tank - Pump tank to sludge tank ashore, open, clean, and dry tank Offset access
cover on two studs leaving tank open to D/H. Bag and tag the remaining securements with new gasket
adjacent to access, ready for assembly. Leave fill and drain valves open. Install blank in vent on top of deck
house. Tank is preserved with P10 Type 1 Grade 30.
NOTE
This item should be worked in conjunction with Item 11. Both should be
the last system to process.
24.
Winches, Anchor - Total of four (4), one (1) each located port and stbd, bow and port and stbd, stern. All will be
processed as follows:
(a)
Cable and Drums. The unpainted surfaces of the drums shall be coated with a water resistant lithium based
grease (MIL-G 10924 ALVANIA EP2 or equivalent). The cables will be coated with the same lubricant and
rewound on the drums.
(b)
Brake Drums - Coat/spray the unpainted surface with rust inhibiting lacquer-resisting synthetic primer
conforming to FED-TT-P-664, commonly called GlyptoL
NOTE
With brake off, rotate drum to apply.
Do not apply brake after the
application of GLYPTOL.
(c)
.
(d)
Enclosed Gears - Fill to operating level with oil specified in lube order or instruction book (GO-90 MIL-L-
2105).
25.
Hydraulic Crane
(a)
Cable and Drum - Coat the cable and unpainted surfaces of the drum with water resistant lithium base
grease (P-11-MIL 10924 ALVANIA EP2 or equivalent).
(b)
Hose Reel - Shore discharge hydraulic.
E-8
|
||
|
||
