| Tweet |
Custom Search
|
|
|
||
 TB 600-1
Stopping Instructions
Stopping Instructions
k.
Position AC circuit breaker
h.
Move AC circuit breaker
in OFF position.
to the OFF position.
*l.
Allow generator set to cool
*i.
Allow generator set to
down at rated speed, three
cool down at rated
to five minutes.
speed, three to five
minutes.
m.
Place start/stop switch to
j.
Move master switch to
stop position.
OFF position.
k.
Pull out DC circuit
breaker.
*
Denotes changes to starting
*
Denotes changes to the
and stopping procedures taken
starting and stopping
from PS magazine, Issue 331,
procedures taken from
June 1980.
PS magazine, Issue 334,
September 1980.
These changes should be placed in the starting and stopping instructions of each Technical Manual.
20.
Insure student's understanding of the starting and stopping instructions.
(10 minutes)
WARNING
All CAUTIONS and WARNINGS contained in this packet should be strictly adhered to. Otherwise, severe
injury, death and/or damage to the equipment may result. Students should be monitored very closely
during starting, operating, and stopping of this equipment.
21.
Have each student start and stop the generator set several times, or until you
(30 minutes)
are sure he/she can properly start and stop the generator set.
a.
Give assistance when needed.
b.
Correct any safety hazards as soon as you see them.
c.
Insure students are following the instructions in the Technical Manuals.
d.
Assign each group of students to a generator set and have each perform the following:
1.
Start the generator set using the appropriate Technical Manual.
Change 3 H-13
|
||
|
||
