| Tweet |
Custom Search
|
|
|
||
 TM 11-5895-1847-12&P
OPERATOR AND UNIT MAINTENANCE
LCU 2000 GLOBAL MARITIME DISTRESS AND SAFETY SYSTEM
OPERATION UNDER USUAL CONDITIONS
INITIAL SETUP:
Personnel Required
Seaman 88K
OPERATE THE NAVTEX RECEIVER
NOTE
The flow chart below shows configuration of commands provided in the NAVTEX receiver.
It is useful if you forget at which command level you are, or if you would like to move to
another setting. Most command levels selected at main menu revert to the main menu
after selecting escape.
POWER ON
Nav. print ready. (Stand-by for reception)
Printer prints
out received ID,
current status
or NMEA (CIF)
Press [MENU] Key
data.
Main Menu
A
Set station
B
Set message
C
Set function
D
Print received ID
E
Print status
F
Print NMEA data
Set function menu
NOTE:
G
End
A Monitor volume
When navigation equipment
B Alarm volume
is not connected
to the receiver, disregard
C Character/line
D Beep
the following steps.
E NMEA(or CIF)
F System clock
G Station select
H Comment
Set CIF item
Press [ENT] Key
A Time
B Heading
C Position
Each talker set
D Speed
E Bearing
A Set position talker
F Wind dir, velocity
B Set speed talker
G Water temperature
C Set bearing talker
H Depth
D Set the print interval
I Current dir, velocity
ESC
ESC (to next step)
Press [ENT] Key
2C036-1
0036 00 1
|
||
|
||
