| Tweet |
Custom Search
|
|
|
||
 TM 11-5895-1847-12&P
0036 00
13. Error rate and message reception status may be added to each message. A comment can be added to messages by
entering H on the Main Menu-C: Set function. The comments printed out are tabulated below:
COMMENT
MEANINGS
(ERROR RATE =0.0%)
NO ERROR IS FOUND IN THE RECEIVED
MESSAGES.
(ERROR RATE = 33%
WHEN THE CHARACTER ERROR RATE EXCEEDS
OVER)
33%, THE RECEIVER PRINTS THIS COMMENT
AND SUSPENDS PRINTING. (SEE NOTE 2)
CORRUPT MESSAGE
WHEN THE CHARACTER ERROR RATE IN ONE
MESSAGE EXCEEDS 33%, THE RECEIVER
SUSPENDS PRINTING AND THE MESSAGE
"CORRUPT MESSAGE" IS PRINTED. (SEE NOTE
2)
NOTE
When a character could not be received due to noise interference, for example,
an asterisk (*) is printed in its place.
Messages carrying message type "D" or serial number "00" are printed regardless
of character error rate.
14. When the receiver, receives a message carrying type "D", it generates an audible ALARM. To silence the
ALARM, press any key.
15. The user setting mode allows you to custom tailor the receiver according to your needs. You can select which
category of message you wish to receive, set monitor speaker volume, specify which data are to be printed, etc.
16. All user settings are contained in the main menu. To get into the main menu press the Menu key. The printout
should look similar to the figure shown below.
*
printing head
ABCDEFG
-------------------------Main Menu-----------------------
A: Set Station
B: Set Message
C: Set function
D: Print received ID
E: Print status
F: Print NMEA data
G: END
2C036-6
17. The printing head is above "A" of "ABCDEFG". Each character corresponds to a Main Menu, which is listed
below them on the printout. To call up a menu, place the printing head above the letter corresponding to the menu
desired by operating the arrow keys (<) or (>) and press the ENT key or "ACCEPT" key.
0036 00 9
|
||
|
||
