| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
CAUTION
The cable should NOT be bent sharply in any direction.
Severe damage may result.
NOTE
Port transmission cable is 27'1" in length. Starboard transmission
cable is 25'5" in length.
REMOVE:
1.
Open and secure engine hatches (refer to parapaph 3-154).
2.
Remove control head assembly (refer to paragraph 3-34).
3.
Using pliers remove and discard cotter pin (1) or e-clip (9) securing cable pivot (2) to transmission
control (4).
4.
Remove cable pivot (2) from transmission control (4).
5.
Remove cable pivot (2) and nut (3) from old (8) and new (7) cable.
6.
Using 5/16 inch open end wrench remove transmission cable clamp (5) and two bolts and nuts (6)
INSTALL:
1.
Butt end of new cable (7) to end of old cable (8) at transmission and wire ends together securely
using solid wire.
2.
Pull new cable (7) into position at control head assembly.
3.
Unwire new cable (7) from old cable (8).
4.
Reinstall cable pivot (2) end nut (3) on new cable (7).
5.
Adjust cable linkage (refer to paragraph 3-36).
6.
Reinstall control head assembly (refer to paragraph 3-34).
7.
Install cable pivot (2) into transmission control (4).
8.
Using pliers install cotter pin (1) or e-clip (9) securing cable pivot (2) to transmission control (4).
9.
Flare end of cotter pin (1).
10.
Using 5/16 inch open end wrench reinstall transmission cable clamp (5) and two nuts and bolts (6).
11.
Close engine hatches.
Change 2
3-79
|
||
|
||
