| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
T M 1940-20/2
REMOVE:
1.
Open and secure engine hatches (refer to paragraph 3-154).
2.
Open and secure battery hatch (refer to paragraph 3-154).
3.
Shut off fuel supply to fuel water separator by turning handle on engine fuel shutoff valve (1) or (2) as applicable.
4.
Loosen tap drain plug (3) from fuel water separator (4) and drain fuel into container.
5.
Using 15 mm open end wrench remove fuel inlet line (5) and fuel outlet line (6).
Drain fuel from inlet and outlet lines into container.
6.
7.
Wipe up spilled fuel.
Using two 17 mm wrenches remove two nuts (7), washers (8) and bolts (9) which secure fuel water separator to
8.
bulkhead support bracket.
9.
Remove fuel water separator (4).
INSTALL:
1.
Fit fuel water separator (4) to bulkhead support bracket.
2.
Install two bolts (9), washers (8) and nuts (7).
Tighten bolts using two 17 mm wrenches.
3
4.
Connect fuel inlet line (5) and fuel outlet line (6) to fuel water separator (4).
5.
Tighten lines using 15 mm open and wrench.
6.
Check and tighten tap drain plug (3) if loose.
7.
Open engine fuel shutoff valve (1 of 2).
8.
Bleed the fuel system (refer to paragraph 3-64).
9.
Close engine and battery hatches.
|
||
|
||
