| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
19.
Connect slave cable to slave receptacle on vehicle: refer to vehicle TM for location of slave receptacle.
20.
Remove slave receptacle cover (1). Connect slave cable to slave receptacle (2).
Do not disconnect stave cable while starter is cranking because this burns the
cable and receptacle contacts.
21.
Have vehicle operator start engine and run engine at fast idle (1000 to 1200 RPM) to charge dead batteries. Charge
for 3 - 5 minutes.
22.
Have boat operator turn master switch on and check port battery condition meter. When the system voltage reads
24 - 25.4 Vdc, batteries are fully charged (TM 5-1940-277-10).
CAUTION
Do not start MK1 boat out of water unless external water supply is used.
23.
Have boat operator start engines and run at fast idle (1000 - 12000 RPM) (TM 5-1940-277-10).
24.
Have vehicle operator turn vehicle master switch off.
25.
Have boat operator turn boat master switch off.
26.
Disconnect slave cable from slave receptacles on vehicles and boat.
27.
Have vehicle and boat operators turn master switches on and run engines at 1000 RPM to build up rundown batter-
ies (3 - 5 minutes).
3-188
|
||
|
||
