Tweet |
Custom Search
|
|
|
||
TM 5-1940-277-20
TM 1940-20/2
Disconnect wire leads (1).
4.
Using 8 mm box wrench remove six nuts (2) and washers (3) securing mounting plate (4) and remove from tank
5.
Using 19 mm open end wrench remove nylon sender unit lock nut (5) and washer (6).
6.
7.
Remove mounting plate (4), seal (8) and fuel level sending unit.
INSTALL:
1.
Using 19 mm open end wrench install washer (6) and nylon nut (5) securing new fuel sending unit (7) and seal (8)
to mounting plate (4).
2.
Using 8 mm box wrench install new fuel level sending unit (7) in fuel tank, taking care that float is oriented for upward
flotation.
Using wire strippers strip 1/4 inch of insulation from end of lead wires (9).
3.
Place stripped wire into barrel of snap wiring terminal.
4.
Using crimper crimp terminals to end of wire leads (1).
5.
Reconnect wire leads (1).
6.
Connect batteries (refer to paragraph 3-88).
7.
Close engine hatches (refer to paragraph 3-154).
8.
3-223
|
||