| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
3.
Disconnect magnetic pick-up connector (1) from harness connector (2).
4.
Using 1-1/8 inch wrench, loosen jamnut (3) and remove magnetic pick-up (4) from flywheel
housing (5).
INSTALL
1.
Remove plug (6) from flywheel housing (5).
2.
Rotate crankshaft with gear barring tool (7) until ring gear tooth is at center hole.
3.
Position magnetic pick-up (4) on flywheel housing (5).
4.
Thread pick-up (4) until it contacts ring gear tooth, then back out magnetic pick up (4) one-half
turn.
5.
Hold magnetic pick-up (4) and tighten jamnut (3) with 1 1/8 inch wrench to 2535 lb ft
(3447 Nm).
6.
Connect magnetic pick-up connector (1) to harness connector (2).
7.
Connect battery ground cable (refer to paragraph 3-90).
8.
Close engine hatches.
3-226.1
Change 2
|
||
|
||
